LED Indicator Diagnostic

 

SOLID GREEN

unlocked and monitoring for faults

 

FLASHING RED-GREEN

unlocked and waiting for unit to reach temperature

 

SOLID RED

locked intentionally, no faults

 

SINGLE FLASHING RED

locked due to an over-temperature event

 

DOUBLE FLASHING RED

locked due to a power failure event

 

TRIPLE FLASHING RED

temperature probe failure or test button was pressed

1
1

Specifications

Primary power: 120 AC -12V DC 500mA UL Certified wall converter
Back Up Power: 9V NiCad rechargeable battery
Test Button: For Health Department to confirm proper locking function
Cooler Protection Temperature: 41F or greater for 30 minutes
Freezer Protection Temperature: 0F or greater for 30 minutes
Refill Cooler Timer Extension: 45 minutes
Refill Freezer Timer Extension: 90 minutes
Primary Power Loss: Automatically locks after 2 minutes, continues monitoring and automatically unlocks if power is restored before a
protection locking event occurs

Programming a new key-fob

The locks are shipped pre-programmed to a P1 key. When installing the lock, the P1 key is needed to unlock the lock and to re-program to a new key-code.

1. Lock the lock using the current key-fob
2. Unlock the lock using the key-fob
3. Press the program button for 5 seconds as shown
4. Point the new keyfob at the LED light and press the center button
5. The LED will flash green when the new keyfob is programmed
6. Test the new key by locking and then unlocking the lock

Frequently Asked Questions

Do I need a P1 key-fob to install the lock?

The FreshIQ electronic lock is preprogrammed to a P1 when shipped from the factory. Once the the lock is installed, use the P1 key to unlock the lock. Once the lock is opened, the key-code can be changed to a custom key-code which can be learned into as many locks as desired.

How do I unlock the unit?

To unlock the FreshIQ, point the P1 key-fob at the lock LED and press large fob button.
Confirm the LED is solid GREEN and the doors are unlocked.

How do I program a new key-fob?

1. Lock the lock using the current key-fob
2. Unlock the lock using the key-fob 3. Press the program button for 5 seconds
4. Point the new keyfob at the LED light and press the center button
5. The LED will flash green when the new keyfob is programmed
6. Test the new key by locking and then unlocking the lock

What is the battery I need for replacement?

Replace the 9V rechargeable battery every 2 years. When the battery is replaced, it is recommended that the unit is
retested.

Can I use the same keyfob for multiple locks?

Yes, the key-fob can be used to access as many locks as desired.  This feature can be very useful as one control key-fob can be used to manage security in a large enterprise, saving both time and money.

Still looking for an answer?

  • Phone: 847-640-7002 M-F 8-5pm CST